Z Axis Router Tool Setting Touch Probe Mach3
- Cnc router mill: Z-Axis tool setting touch plate works w/ Mach3.
- Height：(Approx.) 0.79 inch
- Effective surface of the knife: 0.98 inch diameter
- Z-Axis CNC router mill touch plate Mach3 tool setting probe new milling hot kit.
- Cnc router engraving Mach3 machine tool setting auto-Check instrument 1.38inch Dia.
- Milling tools cnc Z-Axis tool setting touch plate probe Mach3 router mill.
- Cable length 4.33inch , diameter 0.2 square feet,including alligator clips.
- Diameter：(Approx.) 1.38 inch
Connect the wire of this tool check instrument to the tool connector of your Control board of the machine , then the control board’s GND connect to the frame of your router ( the frame of the router and the spindle must have connections)
Two ways to connect this item:
If your interface board has the limit switch port or other probe port, you can connect it to that port .
If your interface board does not have that port, your driver board has that port, you can connect it to the driver board’s limit switch port.
Then in the Mach 3, you need to setup the probe(Mach3 — Config—Ports and Pins—Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero.
(1) Cnc Router Engraving Machine Tool